Welcome to the Gamebase 64 forums. An attempt to document ALL Commodore 64 gameware before it's too late!
GB64 and CCS64 3.4
Moderator: Jimbo
- merlen
- New Member
Post
GB64 and CCS64 3.4
Will there been an update for GB64 to allow it to work with CCS64 3.4? I can't seem to figure out how to get it to work with it. I assume a new GEMUS has to be released?
- Michael Plate
- GB64 Team
- Location: Stockholm
Post
Go to menu GEMUS and select entry for CCS64 v3.
Click on BROWSE and point to the new location of the emulator.
That should make it!
You can also simply overwrite CCS64 with the new version.
To make the new version being auto-detected by the GEMUS setup wizard the file GEMUS.DAT needs to be updated with the CRC value of the new emulator version.
/Michael
Click on BROWSE and point to the new location of the emulator.
That should make it!
You can also simply overwrite CCS64 with the new version.
To make the new version being auto-detected by the GEMUS setup wizard the file GEMUS.DAT needs to be updated with the CRC value of the new emulator version.
/Michael
- Michael Plate
- GB64 Team
- Location: Stockholm
Post
To update the GEMUS setup wizard simply extend the file GEMUS.DAT with following line:
/Michael
Code: Select all
¬CCS64 v3.4¬http://www.ccs64.com¬¬CCS.exe¬523F18C5¬D64;G64;G41;T64;P00;TAP;PRG;CRT¬Y¬CCS64.txt¬c64.cfg¬
- Magnate
- Cool Member
Post
Tick the box right next to the emulator you've selected and you'll see the "Finish" button. It's not very obvious at a glance as the box remains grey, which looks as if you couldn't tick it!merlen wrote:If I select 3.3 (no 3.4 is shown) and browse to the file, all I see is a BACK button.
Return to “The GameBase Frontend”
Who is online
Users browsing this forum: No registered users and 2 guests